Ghost Hunter - Detector Locator EMF EVP Recorder

Ghost Hunter is a interactive APP that allows you to contact entity ghosts through EVP and EMF Technology.

There are tow Modes of Operations "Active MODE" and "Stand ALONE MODE"

Here's how to use in STAND ALONE MODE

BEFORE YOU START USING GHOST HUNTER YOU MUST SET the Pre Gap in the Setting PAGE. The PRE-GAP allows certain amount of Minutes to pass before the next Question is asked to the Entity. The Setting can be found in the TOP Left Corner ICON SIDE Drawer then going to Settings.

1. Open Ghost HUNTER APP

2. Use the Questions Page to start your questions that you would like to ask the Entity in STAND ALONE MODE. Our Ghost Hunter Free Version Has up to 5 Questions that can be asked during a Specified TIME in the Recorder PAGE.

3. HIT the TOP Recorders Button and Press "Record" Button

4. Record your questions you would like to be answered by the Ghost.

5. The Free Version can only record 5 different Questions.

6. If you haven't yet Set the PRE-GAP please go into the Setting PAGE

Recording PAGE:

1. In the Recording PAGE please Press the Start Questions button. You will see a Prompt come up to "Select Hours" you want to ask the Ghosts the Questions while you go to sleep or do something else. After you have selected the Hours then Press the Start Questions Button Again this will start your Automatic Questions that you have set up Earlier in the Questions PAGE.

2. After you have pressed the Start Questions button you can now press the Start Sessions Button and this will start the microphone and EMF Reader recorder together and will begin to Record EMF & EVP Microphone DATA.

Both of the Sensors Graphs will record DATA and store the files into your phone.

3. You can now Place your smartphone in the Attic or anywhere else you think Ghost are present. The Speaker will ask your questions to the Entities that are in the ROOM.

FILES PAGE:

1. Once the Sessions has finished the Files will automatically be stored into the Files Area

2. You can press on the Play Button on the Files & listen to them in FILES AREA. By Pressing on the Play Button will bring up a convenient Quick to read Green Colored Graph. The Three DOT Button the Right of the APP will bring up Options to DELETE FILES.

3. By pressing the Center of the FILE you will bring it into the EVP Analyzer PAGE.

EVP Analyzer PAGE:

1. ONCE a Session FILE has been brought into the EVP Analysis Page all the Graphs will start to show recorded DATA that were recorded during the Session you created.

2. You can use the bottom Toggle Bar to Slow Down or Speed up the listening Session - this will give you better capabilities for detection.

3. The TOP Graph is the Actual EMF that was recorded during the Session/s - you can use this to SPOT any SPIKES in the EMF when Ghosts might have communicating or it could have been triggers by Ghost communication. You can use this to confirm to someone of the anomaly.

4. Just like with our EVP Hunter APP you have the Capability to ZOOM into the EMF Graph for better Detection.

5. The Bottom Graph EVP Graph can also detect anomalies that were recorded.

6. Both of the Graphs are in Sync so you can use them to single out anomalies that might have been detected.

7. We have integrated Reverse and Fast Forward and Play Buttons with Millisecond Counter

TOP LEFT SIDE DRAWER:

Press the TOP 4 DOT BUTTON ON TOP LEFT. Here you will find any Options - Choose any Feature that you Like - Please understand that some of our Features have not been activated Yet and will be available at a Later DATE.

HOW TO USE GHOST HUNTER APP In “ACTIVE MODE”

1. Open Ghost HUNTER APP and GO TO RECORDING PAGE in Recording PAGE JUST HIT Start Sessions Button and this will Activate EMF & EVP Graph Recording DATA. You are now Free to Ask any questions that you have while you are out an about.

2. When you are Finished just HIT the "Stop Session Button" and just Follow Steps From FILES Onward to EVP ANALYZER PAGE & TOP LEFT SIDE DRAWER.

BluFly Matrix Team