GAt16sWiFi

Remote on and off devices connected to the electrical circuit, which is an integral part of this application and works only with it. In the image, this is a small board that is installed on a remote device that they are going to control.

PWM for AC and DC voltage. with adjustment step 1%: from 1% to 100%.

PWM for AC voltage, (the calculation was done for 50Hz, at 60Hz the adjustment step will be a little more than 1%, and at the minimum percentage settings the circuit will not turn on - for example, set the value to 2%, and a sinusoid cuts off the circuit earlier, because the sine wave is shorter in time, so the enable signal will never be output), the PD2 pin of the Atmega16 microcontroller is used with an input signal (high TTL level) when a sinusoid passes zero. When using a sinusoid - 29 independent PWM channels. Without the use of a sinusoid, 30 independent PWM channels.

The ability to save settings for different devices, which are then selected as an option from a list in the application.