Airbrush Design

Airbrush graphics always highlight the impression of the pull of the small line so much.

 The more complicated the pull of the line that is made more visible details of the process. To make it also needed paper isolation as a tool.

But the obstacle, the isolation of paper sold in the market has a limit of thinness only limited to 5-8 mm.

Whereas if you want more thin, manual step by cutting the isolation itself must be done. And sometimes the cutting process takes a long time, and the level of kepresisian pieces sometimes less maximal.

For strip pattern cuts on isolation can utilize a dynamo compressor.

First, prepare considerable isolation. Pair the isolation on the compressor dynamo, before fitting the v-belt first off on the compressor's dynamo.

Second, turn on the dynamo compressor and do the cutting process using cutter. At the time of the cutting process, hold the cutter tightly to make the cut piece precision more perfect.

Creating strip patterns with steps like this can save time and strip patterns can be made as you wish.