Easy DIY Bike Stand Tutorials

Make a DIY bike stand and prevent clutter in your garage.

1. DIY Bike Storage Rack

Instructions

1.First, you’ll need to mark and cut the lumber. The 2x6s will be the uprights that hold the wheels. The 2x4s will simply hold those together, so they do not need to be cut. Measure and cut your 2x6s into 24in sections. You should have 12 of them when you are done. These need to be exact, so measure twice, cut once, yada yada.

2.Since the 2x6s will hold the wheels, we want a nice approach/departure angle rather than sharp, square corners. Rather than measure fancy angles, just use one of your 2x4s as a straight edge. Measure a 2×4 width up from the bottom, and then also back from the end. Connect these two marks via your straight edge and voila! you have the angle for you next set of cuts.

3. Mark both ends of all 12 2×6 sections and then carefully cut off the corners. Use sandpaper to remove any splinters left by the saw blade.

4. With all of the 2×6 sections cut and cornered, we’re ready to screw everything together!

5. The 2x4s will fasten to the cut ends of the 2x6s, so two of the 2×6 sections will double as the ends of the rack. Form the shape of the frame by attaching these two end pieces with two screws in each end. They should be straight up and down, and not protrude below the bottom of the 2×4, however, this isn’t fine cabinetry, so don’t go too crazy.

2. DIY PVC Bicycle Show Stand

Instructions

1.Cut your 3/4 PVC into the correct lengths using a PVC pipe cutter. 2 – 8-1/2″, 2 – 7″, 4 – 5-1/2″

2. You will need to take and cut 2 of the tee’s like so using the hacksaw.

3.Take the uncut tee’s and and insert the 5-1/2″ PVC into each end like so.

4. Take the 4 elbow’s and side them on the other end of the 5-12″ PVC like so.

5. Insert the two 7″ PVC into the other end of the elbows on one of the completed sides like so.

want to know more?

for further information and details, download this now and grab what you want.

please enjoy these Easy DIY Bike Stand Tutorials and give us any feedback.