Фаска с радиусом

Chamfer with radius application.

In chamfer drawings, the radius bevel is usually specified by the outer and inner diameters, bevel angle and radius.

The size from the end of the part to the end of the chamfer on the outer diameter is not always indicated.

May be needed for mechanical processing.

In the application "Chamfer with radius" on the screen-1, the calculation of this size.

Input as per sketch:

L - linear dimension = (outer diameter - inner diameter) / 2 (mm).

R -radius (mm).

Chamfer bevel angle (degrees).

Radius coordinates in the second column of the screen.

On the screen-2 chamfer bevel-radius.

Input as per sketch:

L - linear dimension = (outer diameter - inner diameter) / 2 (mm).

R -radius (mm).

Chamfer bevel angle (degrees).

H - linear dimension chamfer height (mm).

Calculation of the coordinates of the transition point of the bevel to the radius.

Radius coordinates in the second column of the screen.

On screen-3, the calculation of the coordinates of the bevel of the chamfer.

Entering two bevel parameters from:

X, Y, A (bevel angle), PC (bevel length).