BendCraft Quick Conduit bend

BendCraft Quick Conduit bend is an essential calculation tool designed for electricians, MEP engineers, and electrical contractors to quickly and accurately calculate conduit bends on the job site.

Eliminate manual math, reduce material waste, and speed up your installation process with instant, precise bending measurements.

KEY FEATURES:

• Offset Bends: Calculate mark spacing and pipe shrinkage based on obstacle height and bend angles (10°, 22.5°, 30°, 45°, 60°).

• 3-Point Saddle Bends: Easily compute center and outer mark locations to bridge over obstacles.

• 90° Stub-Up Bends: Calculate precise deduct/take-off measurements for standard 90-degree bends.

• 4-Point Saddle / U-Bends: Determine exact mark positions for bypassing larger obstacles or parallel pipe runs.

• Conduit Types & Sizes: Supports standard conduit types (EMT, IMC, Rigid) across common trade sizes (1/2", 3/4", 1", and larger).

• Dual Units: Seamlessly switch between Metric (mm) and Imperial (inches).

HOW TO USE:

1. Select your desired bend type (Offset, 90° Stub, 3-Point Saddle, etc.).

2. Input the obstacle dimensions or target height/angle.

3. Get instant results for mark placements and total shrink value.

4. Mark your conduit and bend with confidence.

Built with a clean, field-ready interface so you can perform calculations quickly, even with work gloves on.