Conduit Bend Calculator

▶ Stop doing bend math on scrap cardboard. Enter your run and the calculator gives you the mark locations for the bend you need, right there on the job.

▶ Cover the everyday bends: offsets with the angle multiplier and mark spacing, three point and four point saddles, ninety degree stubs with take up, and kicks. Shrink is worked out for you so your run lands where you want it.

▶ Pick your bender and pipe. Presets cover common EMT sizes with hand and hydraulic benders, so the take up and multipliers match the tool in your hand.

▶ A clean diagram of the pipe shows every mark and angle, so you see the bend before you make it. Switch between inch and metric so it works on any site.

▶ Save job presets, reuse them, and share a result sheet with your crew. Runs offline in the field, no account needed.

Results are calculated from your inputs and standard bend geometry. Always follow local electrical codes and your own measurements on the job, and double check critical runs before you cut.