FitterForge: Pipe Calculator

FitterForge is an offline calculator toolkit for pipefitters, from Brazier Labs.

Calculate simple and rolling offsets, look up elbow take-offs, measure angles and convert between imperial and metric units.

SIMPLE OFFSET

Calculate centerline travel and run from an offset and fitting angle.

ROLLING OFFSET

Find true offset, travel, run and roll angle from rise, roll and fitting angle.

TAKE-OFF

Look up center-to-end dimensions for supported butt-weld elbows, or calculate an ideal geometric setback.

ANGLE FINDER

Use your device's motion sensors to measure inclination. Hold a reading, set a reference zero and calibrate the tool.

UNIT CONVERTER

Convert fractional inches, decimal inches, feet and inches, millimeters, centimeters and meters. Choose your preferred fraction precision.

MADE FOR EVERYDAY USE

• Works offline

• No account required

• No ads

• Imperial and metric units

• Light and dark appearance

• Copy calculation results

Offset results describe centerline geometry. They do not include fitting take-offs or weld gaps and are not finished pipe cut lengths. Check project requirements, fitting dimensions and measurements before fabrication. Angle measurements depend on your device's sensors and calibration.

Developed by Brazier Labs.

Support: [email protected]